Difference between revisions of "EJTAG"
| Line 8: | Line 8: | ||
== Debugging == | == Debugging == | ||
| − | Attempting to use GNU debugger [http://www.gnu.org/software/gdb | + | Attempting to use GNU debugger: [http:/[[/www.gnu.org/software/gdb]. GDP uses its own Remote Serial Protocol (RDB) to communicate to remote targets. This protocol could be used to communicate with the XINU backends through the current serial connection. Although, this would require additions]] to XINU: communication with the GDB host; altering of exception handler to allow GDB to take control of target processor. |
The use of the EJTAG port on the WRT54-series routers gives the user hardware control of the processor, avoiding the need for strategically placed breakpoints and XINU interrupt subsystem modification. Additionally, requests by the debugger for specicfic data can be aquired directly from registers. The trick to this operation is software that can interpret commands from RDB into EJTAG signals to be sent through the host parallel port, and vice-versa. An implementation of this interpreter can be found at [http://www.totalembedded.com/open_source/jtag/mips32_ejtag.php]. An example of a buffered cable is also available at this location. | The use of the EJTAG port on the WRT54-series routers gives the user hardware control of the processor, avoiding the need for strategically placed breakpoints and XINU interrupt subsystem modification. Additionally, requests by the debugger for specicfic data can be aquired directly from registers. The trick to this operation is software that can interpret commands from RDB into EJTAG signals to be sent through the host parallel port, and vice-versa. An implementation of this interpreter can be found at [http://www.totalembedded.com/open_source/jtag/mips32_ejtag.php]. An example of a buffered cable is also available at this location. | ||
Revision as of 18:35, 1 June 2007
EJTAG is a MIPS-specific extension of IEEE 1149.1, the Joint Test Action Group. Allows interfacing with additional logic in SoC
- direct control of processor for step-by-step debugging
- access to busses and registers
- aids in debugging
- possible usage as additional peripheral data bus
Debugging
Attempting to use GNU debugger: [http:/[[/www.gnu.org/software/gdb]. GDP uses its own Remote Serial Protocol (RDB) to communicate to remote targets. This protocol could be used to communicate with the XINU backends through the current serial connection. Although, this would require additions]] to XINU: communication with the GDB host; altering of exception handler to allow GDB to take control of target processor. The use of the EJTAG port on the WRT54-series routers gives the user hardware control of the processor, avoiding the need for strategically placed breakpoints and XINU interrupt subsystem modification. Additionally, requests by the debugger for specicfic data can be aquired directly from registers. The trick to this operation is software that can interpret commands from RDB into EJTAG signals to be sent through the host parallel port, and vice-versa. An implementation of this interpreter can be found at [1]. An example of a buffered cable is also available at this location.
