Difference between revisions of "Talk:Flash driver/Original"

From Embedded Xinu
Jump to navigation Jump to search
(Added a little G/GL information)
(→‎Terminology: erase-block definition)
Line 5: Line 5:
  
 
== Terminology ==
 
== Terminology ==
 +
 +
Flash is bounded by the rule that to program the software may only change a 1-bit to a 0-bit and cannot change from a 0 to a 1.  Because of this, it is often necesary to erase a block of memory (setting all bits in the block to 1) and then write data to it.  This is known as an "erasae-block".  The majority of these seem to be in the 64 kilobyte range, with the smallest being a massive 8 kilobyte erase-block.  This causes a problem as most file systems work in 512 byte blocks or 2048 byte blocks, both of which are substantially smaller than the smallest erase-block. The [[Flash driver#Logical Flash Interface]] attempts to solve this problem by presenting standard 512 byte blocks to the higher layers while maintaining erase-block regions within physical flash memory.
  
 
== Physical Flash ==
 
== Physical Flash ==

Revision as of 18:21, 5 July 2007

The WRT54GL has a 4MB Intel Flash chip which is able to store CFE, NVRAM settings, an operating system (like OpenWRT or LinkSys' operating system (or even XINU), and optionally a file system. Currently the bleeding edge version of XINU in the flashmem branch has a working Flash driver, though it is not the one on this page and will be replaced with the driver described in this document. GL-series routers have 2 erase-block regions (8-8KB and 63-64KB).

Flash memory remains minimally tested on the WRT54G. XINU reports that the G-series has 2MB of Flash memory, separated into 4 regioins of varying erase-block sizes (1-16KB, 2-8KB, 1-32KB, and 31-64KB).

Terminology

Flash is bounded by the rule that to program the software may only change a 1-bit to a 0-bit and cannot change from a 0 to a 1. Because of this, it is often necesary to erase a block of memory (setting all bits in the block to 1) and then write data to it. This is known as an "erasae-block". The majority of these seem to be in the 64 kilobyte range, with the smallest being a massive 8 kilobyte erase-block. This causes a problem as most file systems work in 512 byte blocks or 2048 byte blocks, both of which are substantially smaller than the smallest erase-block. The Flash driver#Logical Flash Interface attempts to solve this problem by presenting standard 512 byte blocks to the higher layers while maintaining erase-block regions within physical flash memory.

Physical Flash

Logical Flash Interface

Lower Driver (Optional)

Upper Driver