The UART driver is a char-oriented driver designed to work with a National Semiconductor 16550 UART. The driver is responsible for receiving and sending bytes of data asynchronously.
The UART driver is divided into two sections: an upper half and a lower half. The two halves communicate via semaphores and buffers. The lower half is interrupt driven and interacts with the physical hardware. The upper half of the driver interacts with user programs. It does not interact directly with the hardware nor does it spinlock while waiting for the hardware to be ready. The upper half waits on semaphores which are signaled by the lower half to indicate bytes of data or free space are avaialable in the appropriate buffer.
The XINU backends have been equipped with serial ports that are representative of the National Semiconductor 16550 UART. Documentation on the 16550 UART can be found at http://www.national.com/ds.cgi/NS/NS16C552.pdf.
Intialize defines the starting values for all members of the control block: statistical counts are zeroed, buffers are defined, and semaphores are allocated. Also part of the intialization process is setting values in the control and status registers:
- Line control is set to 8 bit, no parity, 1 stop.
- Receiver FIFO full, transmitt buffer empty, and receiver line status interrupts are enabled.
- Hardware FIFOs are enabled.
Upper Half (Read and Write)
Read is part of the upper half of the driver that fills a user supplied buffer with bytes from the input buffer filled by the lower half of the driver. If the input buffer is empty, read waits for the lower half to signal on the input semaphore and indicate bytes are avaiable in the input buffer.
Write is part of the upper half of the driver and places bytes from a user supplied buffer into the output buffer read by the lower half of the driver. If there is no free space in the output buffer, write waits for the lower half to signal on the output semaphore and indicate free space is available in the output buffer.
Lower Half (Interrupt Handler)
The interrupt handler is the lower half of the driver. The 16550 UART sends an interrupt (if enabled) when the transmitter FIFO is empty or the receiver FIFO has reached its available bytes tigger level. Three different types of interrupts are handled by the lower half:
- Line or modem status: The interrupt is merely noted in the UART's statistical counts.
- Receiver hardware FIFO trigger level: The driver moves bytes from the UART's receive hardware FIFO into the input buffer. Received bytes are read from the UART until the Data Ready bit in the Line Status Register is no longer set. The input semaphore is signaled to let the upper half know bytes of data are in the input buffer.
- Transmitter hardware FIFO empty: The lower half fills the UART's transmit hardware FIFO from the output buffer. The interrupt handler fills the transmit hardware FIFO until the FIFO is full or the output buffer is empty. The output semaphore is signaled to let the upper half know bytes of space are available in the output buffer.
The control functions are used to set, clear, and get the input and output flags for the UART driver. Non-blocking flags indicate the upper half read and write functions should perform as much of the requested read or write length as possible, but should not block to wait for the lower half to fill or empty the input or output buffers. When the echo input flag is set, the UART outputs every byte as it is received in addition to placing the byte in the input buffer.
UART_DISABLE_LOOPBACK control functions enable and disable hardware loopback. Beware that loopback is precarious and must be used carefully. Prior to enabling and disabling hardware loopback, the control function ensures the transmitter is completely empty and has completed all previous transmission. It is recommended that you turn off interrupts prior to enabling loopback and after disabling loopback to avoid interleaving output while in loopback mode.